CalAmp GUARDIAN User Manual download pdf (Page 97)

- Pin 5 Signal Ground – RS-232 ground and also radio/modem chassis ground potential.

- Pin 7 Request to Send – RTS raised to RS-232 “High” to start transmit mode and prepare modem to receive data.

- Pin 8 Clear to Send – CTS return RS-232 “High” to RTU/PLC 30 mSec after RTS is raised. Modem is ready to receive

data.

DOX mode operation does not require RTS/CTS handshake control. When data is received on Pin 3 (TXD), data is

buffered and the radio is set to transmit mode. Data is transmitted when the radio/modem is ready to send it.

DOX mode requires 3 wire connections for operation. These are as follows. (See Figure 3 and Table 4, earlier in this

User Manual.)

- Pin 2 Receive Data – Data received by radio and output to a RTU/PLC.

- Pin 3 Transmit Data — Data sent to modem to be transmitted by the radio.

- Pin 5 Signal Ground – RS-232 ground and also radio/modem chassis ground potential.

For technical assistance, contact CalAmp Wireless Network Group Technical Service at

wngsupport@calamp.com.

Guardian™ Serial Modem or Analog Radio for Licensed Spectrum PN 001-5006-000 Rev. 3 | Page 89

1 2 ... 92 93 94 95 96 97 98 99 100

No comments

CalAmp GUARDIAN User Manual Page 97