CalAmp GUARDIAN User Manual Page 94
- Page / 100
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Figure 64 Link Configuration Default tab – Modem Mode
Unlike the T-96SR where all eight channels were programmed one channel at a time, the Guardian has a Default tab
where you can select settings that will be default selections for all eight link channels, making it easy to set all eight
channels simultaneously. (See the figure above.)
- Using the information collected from the T-96SR programming, set the RF Link information to match the system
parameters.
- Channel bandwidth is now selectable for either 25 kHz or 12.5 kHz.
- Set the Tx Power Output to the desired power level: 1-10 Watts.
- The Guardian allows for the OTA data settings to be different from the user COM port settings. Care must be taken
to ensure the OTA settings are the same as the T-96SR system settings.
o Channel bandwidth must match the existing system.
o Data rate (Baud rate) must be the same as the T-96SR.
o Data bits, Parity, and Stop bits must be the same as the T-96SR.
- The Guardian uses a slightly different yet compatible modulation scheme as the T-96SR.
o T-96SR uses DRCMSK modulation.
o Guardian uses 2 Level FSK.
Refer to the parameters collected from the T-96SR programming to set the Modem Settings. Pay close attention to the
Online Diagnostics section. If Online Diagnostics are selected in the T-96SR system, they must be enabled in the
Guardian. Whether or not the Online Diagnostics are output to the Setup port is left to the discretion of the customer.
By selecting Output Online Diagnostics Data to Setup Port, the end user can view Online Diagnostics the same as a T-
Base Diagnostic Port would show them.
All eight RF
channels can
be set by using
the Default
settings tab.
Select proper
COM port
settings to
match
PCL/RTU.
Selection of
Online
Diagnostics is
critical to
proper system
compatibility.
Set CD On level
to desired
signal strength.
RF Link
Settings—
Ensure
parameters
match the T-
96SR settings.
Guardian™ Serial Modem or Analog Radio for Licensed Spectrum PN 001-5006-000 Rev. 3 | Page 86
- Guardian 1
- REVISION HISTORY 3
- Important Notice 4
- Copyright Notice 4
- Regulation Certifications 5
- Certifications 5
- 1 GUARDIAN OVERVIEW 9
- 1.1 GENERAL DESCRIPTION 9
- 1.3 LINK CONFIGURATIONS 10
- 1.4 PHYSICAL DESCRIPTION 11
- 1.4.1 FRONT PANEL 11
- 1.4.2 LED PANEL 11
- 1.4.3 USER INTERFACE PORT 12
- 1.4.4 SETUP AND COM PORTS 13
- 1.4.5 POWER CONNECTOR 14
- 1.4.6 ANTENNA CONNECTOR 14
- 1.4.7 CHASSIS DIMENSIONS 15
- 1.5.1 GUARDIAN RADIO 15
- Table 7 Guardian Demo Kits 16
- Table 8 Guardian Power Cable 16
- Table 9 Guardian Fan Kits 16
- 2.1 SINGLE COVERAGE AREA 17
- 2.2 NETWORK ARCHITECTURE 17
- 2.2.1 POINT-TO-POINT 17
- 2.2.2 POINT-TO-MULTIPOINT 18
- 2.2.4 PEER-TO-PEER 18
- 2.2.5 STORE AND FORWARD 18
- 2.4.1 SITE SELECTION 19
- 2.4.2 SITE SURVEY 20
- 2.5.2 ANTENNA OVERVIEW 20
- 2.5.3 THE WRONG COMBINATION 20
- 2.5.4 GOOD DESIGN PRACTICES 22
- 2.6.1 ANTENNA GAIN 22
- Table 11 Antenna Types 23
- 2.8 RADIO INTERFERENCE 25
- 3 SETUP AND CONFIGURATION 26
- 3.1 INSTALL THE ANTENNA 26
- 4 UNIT STATUS 28
- 4.1.1 LONG ID NUMBER 28
- 4.1.2 SHORT ID 28
- 4.2 DIAGNOSTICS 28
- 4.2.1 ONLINE DIAGNOSTICS 29
- 4.2.2 OFFLINE DIAGNOSTICS 29
- 4.2.3 REMOTE COMMANDS 29
- 5.1 INTRODUCTION 30
- 5.3 PORT SETTINGS 31
- Table 15 Communication Modes 32
- 5.4 PORT STATISTICS 33
- 5.6.1 MODEM SETTINGS 38
- 5.6.2 RF LINK 39
- 5.6.3 COM PORT 40
- 5.9.1 RF LINK 46
- 5.9.2 LOADER SETTINGS 47
- 5.11 VERSION REQUEST 49
- 5.14 OFFLINE LINK TEST 52
- 5.15 OFFLINE DIAGNOSTICS 53
- 5.16 ONLINE DIAGNOSTICS 55
- Figure 32 Online Diagnostics 56
- 5.17 PACKET TEST 57
- 5.18 ARRAY TEST 59
- 5.19 ASCII / HEX TERMINAL 61
- 5.19.1 ASCII TERMINAL 61
- 5.19.2 HEX TERMINAL 61
- 5.21 END TO END TEST 63
- 6 GUARDIAN SPECIFICATIONS 65
- APPLICABLE PRODUCTS 69
- APPLICATION 69
- HARDWARE 69
- PROGRAMMING AND SETUP 70
- SET GUARDIAN PARAMETERS 72
- LINK CONFIGURATION 74
- Pin 4 is 75
- CD or RSSI 75
- PROGRAMMING 76
- Click Write Guardian to 77
- INSTALLATION 78
- 10-pin user 86
- PN 023-3410-109 86
- Interface cable 86
- Note frequencies 92
- Note power 92
- WARRANTY STATEMENT 99
Related products and manuals for Networking CalAmp GUARDIAN
Networking CalAmp Fusion Specifications
(2 pages)
(2 pages)
Networking CalAmp HiPR-900 User Manual
(105 pages)
(105 pages)
Networking CalAmp GEMINI G3 User Manual
(2 pages)
(2 pages)
© 2020, manymanuals.com. All rights reserved. | 0.499 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals