1.4 PHYSICAL DESCRIPTION
Guardian consists of two PCBs, one that includes the modem circuitry and the other the radio module. Both are
installed in a cast aluminum case. The unit is not hermetically sealed and should be mounted in a suitable enclosure
when dust, moisture, and/or a corrosive atmosphere are anticipated.
The Guardian is designed for easy installation and configuration; the Guardian features no external or internal switches
or adjustments. All operating parameters are set via the setup port.
1.4.1 FRONT PANEL
The front panel has the following connections.
• (1) 8-Pin user interface block connector
• (1) 50-ohm TNC female Antenna connector
• (1) 50-ohm SMA female receive antenna connector (Dual-Port and Full-Duplex models only)
• (1) Right-angle power connector (10-30 VDC)
• (2) DE-9F RS-232 ports
• For Dual-Port or Full-Duplex Guardian connections, see Section 1.4.6.
Figure 1 Guardian Front Panel
1.4.2 LED PANEL
The LED panel has five Tri-Color LEDs. The functionality of each LED is shown in the following table.
Table 2 Guardian LED Functionality
Amber (Solid or Blinking)
Guardian ready, normal operations
Guardian is programming
Red
Amber (Solid or Blinking)
Guardian no fault conditions, normal operations
Guardian has a fault condition, check unit status
Guardian detects high background noise
Guardian™ Serial Modem or Analog Radio for Licensed Spectrum PN 001-5006-000 Rev. 3 | Page 3
Comments to this Manuals