CalAmp GUARDIAN User Manual download pdf (Page 92)

Figure 62 T-96SR Setup Parameters – Frequencies

Set Guardian Parameters

Once the parameters for the existing T-96SR system are logged, connect the Guardian to proper power supply voltage

(10-30 VDC 60 watt maximum at 10 watt RF power). Connect the antenna port to 50 ohm termination. Connect DE-9 to

DE-9 data cable (PN 697-4008-408 or equivalent to the Guardian Setup port.

Note: The Guardian FPS is set for COM1 by default. Change this if necessary.

- Programming parameters are 57,600, 8, N, 1, DTR, None.

- Handshaking should be set to Buffered with no HS.

With the Guardian connected to proper power source, antenna terminated, and programming cable connected to the

Setup port of the Guardian, click Config (at the upper left corner of the programming window) to access the Guardian

Configuration window.



The Guardian FPS will read the current configuration of the Guardian that is connected to the computer. The

configuration window will display configuration settings of the Guardian, including the Long ID and Short ID of the

Guardian. The Long ID is typically a six-digit number. This number can be changed to suit the application. See the

following figure.

Note frequencies

for both receive

and transmit.

Note power

output settings.

Guardian™ Serial Modem or Analog Radio for Licensed Spectrum PN 001-5006-000 Rev. 3 | Page 84

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 98 99 100

No comments

CalAmp GUARDIAN User Manual Page 92