CalAmp GUARDIAN User Manual download pdf (Page 72)

Figure 41 DL-3400 Setup Parameters – Advanced

SET GUARDIAN PARAMETERS

Once the parameters for the existing DL-3400 system are logged, connect the Guardian to proper power supply voltage

(10-30 VDC 60 watt maximum at 10 watt RF power), Connect antenna port to 50 ohm termination. Connect DE-9 to DE-

9 data cable (PN 687-4008-408 or equivalent) to Guardian Setup port.

Note: Guardian FPS default communication port is COM1. Change this if necessary.

- Programming parameters are 57,600, N, 1, DTR – None.

- Handshaking should be set to Buffered with no HS.

With the Guardian connected to a proper power source, antenna terminated, and programming cable connected to the

Setup port of the Guardian, click Config (at the upper left corner of the programming window) to access the Guardian

Configuration window.

Figure 42 Config button



The Guardian FPS will read and display the current configuration of the Guardian that is connected to the computer.

See the following figure. Selecting Loader mode will change the configuration screen to allow analog radio settings.

Note any

changes to the

Advanced tab

settings.

Factory default

setting for TX

power output is

5 watts.

Guardian™ Serial Modem or Analog Radio for Licensed Spectrum PN 001-5006-000 Rev. 3 | Page 64

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 99 100

No comments

CalAmp GUARDIAN User Manual Page 72